The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
Now everything is permeated with new modern technologies associated with the transmission of sound and video over the network, and there is a very strong lack of engineers who could set it up correctly, especially in small distant cities,I would like...
During Cisco Catalyst Center deployment, you cannot complete the following. $maglev package status automation-core NCP - Services 2.1.617.60344 DEPLOYMENT_ERROR - Exception in task - Maximum wait time 5400 seconds exceeded for the follow...
https://community.cisco.com/t5/security-knowledge-base/ise-version-upgrade-matrix/ta-p/3653501 I will be upgrading from 2.7 to 3.0.What patches are required from 2.7?The table on the left says the last patch is required,The table on the right says y...
Hello all,I am in the process of migrating from a core switch 4x SG500XG-8F8T in a stack, to a core switch 4x CBS350-24XTS.Now I noticed with the lags that only 8 lag groups can be created there. Previously there were 32 on the SG500XG 8F8T.I don't u...
Hello Everyone,Has any of you experience this problem? We have an SX80 running on CE 9.15.x and it's currently being controlled by a Crestron Touch Panel. I tried plugging in a Touch 10 directly to SX 80 but the Touch 10 is not showing any on-screen ...
Hi Everyone,We have few Cisco SX80s in Our infra, Which we are using for Video conferencing between our offices and our clients.We are using static NAT for these devices, Can anyone suggest is it required to Keep the static NAT or can we remove it.A...
I'd like to setup some automated tests based on time increments or set times. Is there a way to do this without an outside stimulus? I guess i could setup an http request from another monitoring system - worst case.
I have Cisco ISR 4451. I has interface Gi0/0/0I want to set the port to 1000/full.Is the below command command sufficient ?interface GigabitEthernet0/0/0speed 1000no negotiation autoOr should i also need to add "duplex full"Let me know.
Hi all;Based on Cisco's published documents, everywhere Cisco explains about configuring TrustSec settings for ASA in ISE, the documents omit the CoA configuration. For example:Does Cisco ASA support pushing TrustSec configuration from ISE side?Thank...
Hello Team, Need assistance from ISE engineer who already running ISE deployment on 3.3 version. currently we are on 3.2 with latest patch, planning to upgrade to 3.3 with patch 2 only because 3.3 allow multiple integration features, before going to ...
I finally got to reserve the Meraki Sandbox but when I logged in there were no appliances. No MX, no switches, no Cameras, AP's nothing. Its like this a brand new install. All it has is a network called branch office. Is there a solution for this?