Most Servers integrate a Baseband Managment Controller with and IPMI, LOM and often iKVM into the Mainboard.

• The main difference between Server and Desktop / Workstation Mainboards - aside from being designed with Server Chassis in mind, is the existance of said LOM.
  • The lack of a LOM makes it harder to upcycle and convert older systems into a Server.
    • It also allows to basically use any system as a Server!

Save time and resources by using older systems as servers.

• This is ideal for small-scale and non-critical "learning" and "testing" envoirments.

Ideal for Legacy Setups that may have to be installed in sensitive areas and likely out of reach of technicians.

• I.e. Industrial and/or medical systems that are in seperately compartmentalized rooms.
  • Can also be used for remote installations that may otherwise necessitate costly hands-ons.
    • I.e. restarting a system that may not be responsive.

• In some sensitive setups, it may be necessary to transparently record all interactions done with the system.

Fits on low-profile PCIe brackets

Since the idea of a LOM is to be hooked up to a network, it is reasonable to assume that PoE is avialable or can at least be injected easily.

via Standby-Line from ATX Power Supply [5v_SB or Similar]

As it's being spliced into the Power & Reset Buttons'- as well as Power & Activity LEDs' Lines, the LOMcard can:

• See if the system is powered on
• See if the system has activity
• Send a Shutdown signal [power button "press"].
• Make a hard shutdown [long power button "press"].
• Do a reboot [reboot button "press"]

For installing in 1U Servers which only have extremely narrow heights.

• Provides the PoE Port and 3 LEDs [PoE, Power/Activity, Programmable via GPIO]

Onboard USB to RS-232 Adaptor with Nullmodem/Crossover and Pin Header to connect to a serial port.

To connect to Mainboards that don't have any Serial Header onboard.

Supporting a full KVM for OSes that don't support serial consoles

• Connects to local Display/Keyboard/Mouse ports.

Allows for fully remote use of the System.

• Ideal for Installers or updating live distributions over the network.
  • Needs to shutdown the "Host"-System to safely dismount and remount the storage.

• Cheap
• Versatile
• More GPIOs than anyone would ever need.

• Providing Power to the LOMcard

• Allows the use of Standby Voltage [i.e. ATX 5V_SB] to run the LOMcard
  • Reduces the Necessity for a PoE connection.

• Needed for PiKVM

• Needed for PiKVM
  • To accept the Video

• Needed for PiKVM
  • Needed for the HDMI2CSI board on Systems without HDMI-output
    • Alternatives like DP-to-HDMI or DVI-to-HDMI can be designed as well.

• To provide a "Serial Console" on Systems without an RS-232 port.
  • Ideal for UNIX-alike OSes like FreeBSD, Linux, etc.

• Requires PiKVM
  • Allows to be rewritten and booted from
    • Connects via USB
      • Is being switched between LOMcard and "Host"-System
  • Recommended to be used with Ventoy
    • But can be reflashed with basically anything.