Min, S.-H.; Suh, H.-K. Effect of Premixed Ethanol Ratio Based on the Same Heating Value on the Atomization of Diesel Fuel Injected in the Cylinder. Fire2023, 6, 249.
Min, S.-H.; Suh, H.-K. Effect of Premixed Ethanol Ratio Based on the Same Heating Value on the Atomization of Diesel Fuel Injected in the Cylinder. Fire 2023, 6, 249.
Min, S.-H.; Suh, H.-K. Effect of Premixed Ethanol Ratio Based on the Same Heating Value on the Atomization of Diesel Fuel Injected in the Cylinder. Fire2023, 6, 249.
Min, S.-H.; Suh, H.-K. Effect of Premixed Ethanol Ratio Based on the Same Heating Value on the Atomization of Diesel Fuel Injected in the Cylinder. Fire 2023, 6, 249.
Abstract
The objective of this study is to investigate the effect of the premixed ethanol ratio based on the same total heating value in-cylinder on the equivalence ratio distributions and the injected fuel droplet behavior in the cylinder of the RCCI engine. The spray simulation was conducted by dividing two-part. First, the spray validation simulations progressed to find the spray-influenced factor of the test injector. Next, the engine simulations were performed with the spray-influenced factor obtained from spray validation simulations to investigate the effect of the premixed ethanol ratio based on the same total heating value in-cylinder on the injected fuel atomization and the equivalence ratio distributions. The introduced total heating value was fixed at 595J based on the lower heating value of diesel 14mg. The heating value of the premixed ethanol ratio varied from 0% to 40% based on the same total heating value in-cylinder in steps of 10%. It was revealed that when the premixed ethanol ratio based on the same total heating value in-cylinder was increased, the spray tip penetration value was reduced from the time after 4deg of diesel injection start because of the short injection duration by the small amount of diesel fuel. The SMD value was also more enormous up to 32.58% with increasing the premixed ethanol ratio because of the low kinetic energy of the injected fuel by the short injection duration and the slow evaporation of the injected fuel by the low cylinder temperature.
Keywords
Keywords Air Emissions from Fossil Fuel Combustion; Fuel Combustion; Energy Conversion/system; Energy Systems Analysis
Subject
Engineering, Mechanical Engineering
Copyright:
This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.